Friday 7 February 2020

My 1798 Irish Rebellion companies for 'Rebels and Patriots'

These are my 28mm 1798 Irish Rebellion companies for Rebels and Patriots. I’ve been buying them from North Star using my monthly Wargames Illustrated discount. All the figures are Trent Miniatures. They have great character and required only minimal cleaning up.

United Irishmen. The units are a mixture of pikemen and gunmen. The skirmishers (bottom left) are Shelmaliers. The command figures (bottom centre) will be put into one of the pike units. The remaining figures (bottom right) are spares for different configurations.

There are no silly cast pikes but no open hands either, so the hands had to be drilled. I started with a pin vice but the metal was quite hard so I dug out my old modelling drill and upgraded the power unit from 9v to 12v.

It’s some time since I’ve used this so I had to decide on technique:

1. Start the hole with a pin vice hand drill which is more controllable than the electric drill. Once the hole is started you can get a purchase with the latter. If going through two hands, start each one with the pin vice.

2. Don’t just drill. It will jam. Keep pulling it out and pushing it back in again. This doesn't seem to happen with the pin vice.

3. Avoid letting the drill slip under a finger nail - it's uncomfortable and may cause delay.

The figures came with sharp wire pikes. I shortened these to 60mm to represent Irish half-pikes.

Irish Militia etc comprising two units of Line Infantry (centre row), Grenadiers (bottom left),  Light Infantry (bottom right), Yeoman Cavalry (at the back) and Artillery. The mounted Captain (next to the gun) replaces an ordinary figure in whichever unit he is put with.

The Crown troops required a lot less work. Many of the Militia (and Rebels) came with separate heads. This provides good variation for the Rebels but less so for the Militia. The Militia heads can be angled a little differently, but only up to a point.

4 comments:

  1. This is looking good Richard!

    ReplyDelete
    Replies
    1. I think they will give a different twist to playing the rules, if only aesthetically.

      Delete
  2. Not sure I have the skill to operate a power drill for this operation. Plunging a fast spinning drill bit into one's hand seems highly likely with a slight slip. I always stick with a pin vise for drilling out hands. Well, unless it is MY hand I wish to drill out!

    ReplyDelete
    Replies
    1. Only one slip and it didn't really hurt! Scalpel work is worse. How we suffer for our hobbies...

      Delete